|
|
D. Sivarama Krishna CCNA Questions Dump: 640-607
Dated: 24-March-2003
1. Which
key do I press to have the IOS finish typing a known command for me?
[A.]
<Tab>
[B.]
<Ctrl R>
[C.]
<Spacebar>
[D.]
<Right Arrow>
Answer: A
2. Which
layer of the OSI model handles data translation, code formatting, and
encryption occur?
[A.]
Physical
[B.] Data
link
[C.]
Network
[D.]
Transport
[E.]
Session
[F.]
Presentation
Answer: F
3.
Consider Frame Relay multipoint sub interfaces.. Which is a valid statement?
[A.] An
IP address is required on the physical interface of the central router.
[B.] All
routers are required to be fully meshed.
[C.] All
routers must be in the same subnet to forward routing updates and broadcasts.
[D.]
Multipoint is the default configuration for Frame Relay sub interfaces.
Answer: D
4. If RIP
uses hop count to determine the best path what does IGRP use?
[A.] The
highest metric value.
[B.] The
lowest composite metric value.
[C.] The
lowest hop-count and delay.
[D.] The
highest bandwidth and reliability
[E.] The
lowest administrative distance.
Answer: B
5. You
need to perform password recovery. One of the first steps in performing
password recovery is recording the current configuration register setting from
user mode. What is the command to view the configuration register?
[A.] Show
register.
[B.] Show
flash.
[C.] Show
boot.
[D.] Show
version.
Answer: D
6. You
have installed a new PC to your access layer switch. You have configured the IP
address, subnet mask, default gateway, and DNS settings. You have verified that
the information you have entered is correct and that the proper cable was used
however this PC is unable to access devices that are connected to the same
switch. What is the likely cause of this problem?
[A.] The
router lacks a routing table entry for the new host.
[B.] The
host switch port is assigned to the incorrect VLAN.
[C.] The
host MAC address is incorrectly configured.
[D.] A
VTP instance for the new host has not been installed.
Answer: B
7. If you
take a dotted-decimal class A IP address such as 10.0.0.1 and convert the first
octet to binary. Which of the following is the correct bit pattern for the
first octet?
[A.]
0xxxxxxx
[B.]
10xxxxxx
[C.]
110xxxxx
[D.]
1110xxxx
[E.] 11110xxx
Answer: A
8. What is the benefit of segmenting a network
with a router into two different segments called segment one and segment two?
[A.] It
increases the number of collisions.
[B.] It
decreases the number of broadcast domains.
[C.] It
connects segment one's broadcast to segment two.
[D.] It
prevents segment one's broadcast from getting to segment two.
Answer: D
9.
Looking at the diagram above ports 1 through 4 are assigned to VLAN1 and ports
5 through 8 are assigned to VLAN3 on each switch. The switches are
interconnected over an ISL trunk link. Which of the following actions would
test proper VLAN and trunk operation? (Choose three.)
[A.] Host
2-1 can ping Host 2-2
[B.] Host
2-1 can ping Host 7-2
[C.] Host
2-1 can not ping Host 2-2
[D.] Host
7-1 can not ping Host 2-2
[E.] Host
7-1 can ping Host 7-2
Answer:
A, D, E.
10. You
have just purchased a new Cisco router. Which mode should you use to create an
initial configuration on your router?
[A.] Copy
mode.
[B.] User
mode.
[C.]
Setup mode.
[D.]
Startup mode.
Answer: C
11. What
can you use to telnet from a user's pc directly to a router?
[A.]
Connect the PC's COM port to the router's console port using a straight-through
cable.
[B.]
Connect the PC's COM port to the router's console port using a crossover cable.
[C.]
Connect the PC's COM port to the router's Ethernet port using a
straight-through cable.
[D.]
Connect the PC's Ethernet port to the router's Ethernet port using a crossover
cable.
[E.]
Connect the PC's Ethernet port to the router's Ethernet port using a rollover
cable.
[F.]
Connect the PC's Ethernet port to the router's Ethernet port using a
straight-through cable.
Answer: D
12. Two
types of frame tagging are ISL and 802.lq. What is the purpose of Frame
Tagging?
[A.] They
provide best path determination.
[B.] They
allow the exchange of filtering tables.
[C.] They
specify different implementation of the Spanning-Tree Protocol.
[D.] They
provide interswitch VLAN communication.
Answer: D
13. Which
command will provide you with information regarding the Layer 3 IP address of a
directly connected neighbor?
[A.] Show
ip interface
[B.] Show
cdb neighbors
[C.] Show
cdp neighbors detail
[D.] Show
ip route
[E.] Show
ip link status
[F.]
Telnet
Answer: C
14. To
perform password recovery on a Cisco router you have to modify which of the
following? (Choose two.)
[A.]
Nvram
[B.]
Configuration register
[C.] Boot
flash
[D.] Cmos
[E.]
Flash
Answer:
A, B
15. Which of the following are Application layer
protocols that use TCP/IP? (Choose three.)
[A.] ARP
[B.] HTTP
[C.] SMTP
[D.] FTP
[E.] ICMP
Answer:
B, C, D
16.For
what purpose does Frame Relay use DLCIs?
[A.] They
determine the Frame Relay encapsulation type.
[B.] They
identify the logical circuit between a local router and a Frame Relay WAN
switch.
[C.] The
represent the keepalives used to maintain the PVC in an active state.
[D.] They
represent the physical address of the router attached to a Frame Relay network.
Answer: B
17. Frame
relay has a feature that prevents PVCs from shutting down from lack of
activity. What is the name of this feature?
[A.] DLCI
[B.] BECN
[C.] FECN
[D.] LMI
[E.] CIR
[F.] De
Answer: D
18. There
are some differences between routed and routing protocols. Which of the
following are examples of those differences? (Choose two.)
[A.] A
routed protocol is assigned to an interface and determines the method of packet
delivery.
[B.] A
routing protocol determines the path of a packet through a network.
[C.] A
routed protocol determines the path of a packet through a network.
[D.] A
routing protocol operates at the transport layer of the OSI model.
[E.] A
routed protocol updates the routing table of a router.
Answer:
A, B
19. You
issue the debug ip rip command to troubleshooting the rip network. You notice
your Ethernet interface 10.1.0.0 shuts down. Which update message is seen in
your routers debug ip rip output regarding that network?
[A.]
Subnet 10.1.0.0, metric 0
[B.]
Subnet 10.1.0.0, metric 1
[C.]
Subnet 10.1.0.0, metric 15
[D.]
Subnet 10.1.0.0, metric 16
Answer: D
20. Which
of the following devices support Full Duplex Ethernet ? (Choose two.)
[A.]
Switch to host.
[B.]
Switch to switch.
[C.] Hub
to hub.
[D.]
Switch to hub.
[E.] Hub
to host.
Answer: A,
B
21. Cisco
has just released a new version of Cisco IOS and you would like to use this new
version You have downloaded this IOS from Cisco's web site and stored it on
your TFTP server. Which of the following commands should you use to copy this
IOS to your router?
[A.] Copy
flash ftp.
[B.] Copy
ftp flash.
[C.] Copy
flash tftp.
[D.] Copy
tftp flash.
Answer: D
22. Users
on your network 10.1.0.0/16 are complaining that they cannot access the
company's intranet server using the FQDN www.snowball.com. You are able to ping
the IP address but you can not ping www.snowball.com.
What is
the likely cause of this problem?
[A.]
TCP/IP failure.
[B.] DNS
failure.
[C.] FTP
failure.
[D.] SNMP
failure.
Answer: B
23. Using
a protocol analyzer we noticed sustained, heavy collisions in our CSMA/CD LANs.
What are some possible affects could this have our LAN? (Choose three.)
[A.]
Increased broadcast traffic.
[B.]
Delay.
[C.] Low
throughput.
[D.] High
throughput.
[E.]
Congestion.
[F.]
Higher bandwidth.
Answer:
B, C, and E
24.
Exhibit
Click for
Exhibit
You are
network administrator for the network shown in the exhibit above. The network
has recently been augmented by adding the new router CS2. You would like to
backup the IOS image of the new router to the TFTP server. However, the backup
procedure fails. What could be the cause of the problem?
[A.]
Incorrect default gateway of the tftp server.
[B.]
Incorrect subnet mask of the tftp server.
[C.]
Incorrect IP address of the tftp server.
[D.]
Incorrect IP address on E0 of the CS1 server.
[E.]
Incorrect subnet mask on the CS2 router.
Answer: B
25. Which
channels are used by ISDN BRI?
[A.] 2d+b
[B.]
23d+b
[C.] 2b+d
[D.]
23b+d
Answer: C
26. You
need to segment your network which of the following hardware devices can you
use to segment your network? (Choose three.)
[A.] Hub
[B.]
Repeater
[C.]
Switch
[D.]
Bridge
[E.]
Router
[F.]
Media converter
Answer: C,
D, and E
27.if
Serial port is down and line protocol is down what could be the problem
[A] Network Layer
[B]. Physical Layer
[C] Data Link Layer
[D] Transport Layer
Answer: B
28. If
Administrator Shutdown the Interface serial 0 what will be the out put of Show
Interface s0
[A] Serial down line protocol down
[B] Serial Up line protocol down
[C] Serial Administratively down line
protocol down
[D] Serial Administratively down and line protocol up
Answer: C
29. What is the Subenet mask of the 172.16.x.0 /28 network 255.255.25.224
-------------------
30.Find the subnet mask of ip address 172.16.x.0 if we required 438 hosts per network
Answer: 255.255.254.0
31. The command to see available protocols on your network sh
ip protocols
32. What spans the OSI layer 7 model completely (choose3)
[A] Network Host
[B] Network Management Server
[C] Hub
[D] Switch
[E] Web server
Answer: A, B and E
33. Identify the command to set the clock rate for DCE
interface clock rate
34. What is the Base Mean in 100 Base T? Signaling
35.Simulator one: Connectivity lost among the 3 routers one router has in correctly assigned IP address. Correct it and it comes up.
36. Simulator two: Configuring RIP on one router
37. Which of the following are generally considered to be characteristics of connection oriented network service
[A] non–reliable
[B] Reliable
[C] Less bandwidth intensive
[D] Hand Shaking
Answers: B and D
38. Mr. X has received a call from a user Y who is unable to reach a remote site after further review he discover the following information
Local PC –10.0.5.35/24
Default gateway – 10.0.3.0
Remote Server – 10.0.5.250/24
Ping 127.0.0.1 –Successful
Ping 10.0.5.35 – unsuccessful
Ping Gateway – unsuccessful
Ping Remote server – unsuccessful
Which of the following problems would be create the test result
[A] TCP/IP is not installed correctly
[B] Local Physical Layer Problem
[C] Local NIC not functioning
[D] Remote Physical Layer Problem
Answer: A
39. Identify the classes of the following bits
a . 011xxxxx. Xxxxxxx.xxxxx.xxxx
b. 110xxxxx.xxxxxxxx.xxxxxxx.xxxxxx
c. 0011xxxx.xxxx.xxxx.xxxxx
[A]. a is a class A address and b is a class B Address
[B] a is a class C address and b is class A address (blah blah…)
40. If user X Workstation has connected Router A through Console cable. If user X wants to take the Back up of IOS, what are the prerequisites? (Choose three)
[A] Sufficient Space is required on Router
[B] IP address of Users Workstation
[C] TFTP server should run on Users workstation
[D] User X workstation and Router A should be in same Subnet
41. Default Metrics of IGRP Bandwidth and Delay
42. One Drag and drop question related to ISDN Map steps
43. Routers Startup config will stores on which location
[A] NVRAM
[B] ROM
[C] FLASH
[D] TFTP Server
44. Which WAN technology is using two protocols one is for data and another is for signaling
[A] ISDN
[B] Frame Relay
[C] X.25
[D] Some thing
Answer: A
45. What are the two authentication Methods of PPP encapsulations?
Answers: CHAP and PAP
46. What are the advantages of PPP over HDLC?
[A] PPP is supports multi vendors
[B] Provides Authentication
and some other options
############################&&&&&&#################################